Nice Spido Instructions And Warnings For Installation And Use

28 – ENGLISH
Wiring diagram with relay photocells with PHOTOTEST
1
2
345
6
78
LR
LK
DISPLAY
LED OK
LS
LED STOP
LED
RADIO
FUSE
SbS
PHOTO
12V
STOP
GND
PHOTOTEST
FLASH
RX
TX
21 543
1 2
+12V - OSE
FLASH
NO
NC
OSE
8k2
NO
+24V (COMMON)
54
9.1.3 Electric lock
The PHOTOTEST output is by default enabled for the PHOTOTEST
function, but can be programmed for controlling an electric lock
(see the “Setting the PHOTOTEST operation” chapter on page
20).
At the start of the opening movement, the output is activated for
2 seconds, while during the closing manoeuvre it is not activated,
therefore the electric lock must reset mechanically.
The output cannot control the electric lock directly, but only loads
of 24 V c 3 W.
The output must be interfaced with a relay, as shown in the gure.
1
2
345
6
78
A
C
B
55
A Electric lock
B 24 V c support relay
C Electric lock power supply
9.2 CONNECTING AND INSTALLING THE BACK-
UP BATTERY
f
The electrical connection of the battery to the con-
trol unit must be made only after completing all the
installation and programming stages, as the battery
is an emergency power supply.
To install and connect the battery:
1. loosen the screw (A)
2. pull the cover (B) slightly outwards and turn it downwards
(“Figure 56“)
A
B
56

Nice Spido Specifications