10
Chapter 1: Getting Started
This chapter provides instructions for unpacking, checking, connecting and using the OpenSPR™ and
XT add-on.
1.1 Initial Equipment Setup
1.1.1 Before any Steps are Taken
1. Read the entire Safety and Preparation for Use section of this manual before starting any set
up procedure. DO NOT PROCEED TO USE THE INSTRUMENT IF YOU SUSPECT IT HAS BEEN
MODIFIED OR DAMAGED OR IF YOU ARE UNSURE OF THE SAFETY OF THE INSTRUMENT.
2. Read and follow all installation and operation instructions in this manual to ensure that the
performance of this instrument is not compromised.
3. Open the boxes and inspect all components of the OpenSPR-XT™ system.
4. Report any damage to Nicoya Lifesciences Inc. immediately.
5. Compare the contents of the shipping boxes against your original order and the checklist
below. Report any discrepancies to Nicoya Lifesciences Inc. immediately.
1.1.2 Standard Equipment Supplies
OpenSPR™ instrument with XT Autosampler Add-on
Cables:
o 2 power adapters (for OpenSPR and XT add-on)
o 2 USB connectors
1 Sample holder with blank Sensor Chip installed
Tubing for Inlet and Outlet
2 Drain Hoses
2 Flow Cells (1 installed and 1 replacement)
1 500 mL Buffer Bottle
1 250 mL Wash Bottle
1 Sampler Needle (installed)
1 USB Drive containing OpenSPR™ software set-up files, manual and other relevant
documentation
1 Allen Key
To Next Page
Loading...
