6
Operating Conditions
The following are the recommended operating conditions of the OpenSPR™ instrument and should
be followed for safety and performance purposes.
1. Read and follow all instructions provided.
2. For indoor use only.
3. For research use only.
4. Assure proper ventilation while in use.
5. Use this system only for its intended use. Use of the system for any other purpose may cause
unsafe situations.
6. Do not use the system if there is any visible damage.
7. OpenSPR™ and XT add on is not waterproof – do not spill liquids onto it and be very careful of
leaks.
8. Do not operate the system in the presence of strong magnetic fields.
9. Dust may interfere with the instrumentation, it is recommended that compressed air be used
to remove any dust that may accumulate in the system after completing tests and that the
unit is stored with a closed lid.
10. Handle Sensor Chips with tweezers and while
wearing gloves [Figure 0.1] and other appropriate
personal protection equipment. If skin contact with
the Sensor Chip occurs, rinse exposed area with
water for 15 minutes.
11. Tubing under stress – be very cautious when undoing
fluidic connections.
12. Carefully inspect tubing and connections prior to
testing.
13. The tubing in the peristaltic pump will wear over time. Contact Nicoya Lifesciences for a
replacement when needed.
14. It is the responsibility of the user to ensure the safety and appropriateness of the chemicals,
materials, and fluids being used in the OpenSPR™ and XT add-on.
15. Treat sensors as hazardous waste after use and follow all local, state/provincial, and federal
regulations. Contact a licensed waste disposal specialist for proper disposal.
Figure 0.1 - Handle chips with gloves and
tweezers
To Next Page
Loading...
