Chapter 27. Capturing Simultaneous Photo Activation Imaging (Resonant & Galvano Scanner) A1
88
(2) Set the photo activation time settings.
Wait: Set the waiting time until activation starts.
Interval: Set the time interval of photo activation.
ROIs: Set stimulation groups used for activation.
Duration: Set the duration time of photo activation.
When [Loops] is set, duration is automatically determined.
Loops: Set the number of photo activation execution times.
(3) Set the time series time settings.
Duration: Set the duration time of image acquisition.
When [Loops] is set, duration is automatically determined.
Loops: Set the number of image acquisition execution times.
(4) Check the [Save to File] checkbox to acquire images while saving them.
Note: Images are saved in nd2 file format.
Note: We recommend acquiring time series images while saving them.
(5) Click
to read the settings for photo activation simultaneous imaging.
(6) Click the [Run now] button to start photo activation simultaneous imaging.
(4)
(3)
(2)
(5)
(6)
To Previous Page
Loading...
