Figure 3-29. Rename a Custom Picture Control
3. Select one of your Custom Picture Controls from the list
(C-1 to C-9) and scroll to the right (see Figure 3-29,
image 3). I selected to rename NEUTRAL-02. This is
the Custom Picture Control I created under the Save/edit
section.
4. You’ll now be presented with the Rename screen. To
create a different name, hold down the Thumbnail/
playback zoom out button and use the Multi Selector to
scroll back and forth within the old name. When you
have the small gray cursor positioned
over a character, you can delete that character with the
garbage can Delete button. To insert a new character,
position the yellow cursor in the character list above and
press the Multi selector center button on the D300S or
the center of the Multi Selector on the D300. The
character that is under the yellow cursor will appear on
the name line below, at the position of the gray cursor. If
there is already a character under the gray cursor, it will
be pushed to the right. Please limit the name to a
maximum of 19 characters (see Figure 3-29, image 4).
5. Press the OK button when you have completed the new
name. I renamed the Custom Picture Control previously
named NEUTRAL-02, in Figure 3-29, to
NEUTRAL-EXSHARP.
Note: You can have more than one control with exactly the
same name in your list of Custom Picture Controls. The
camera does not get confused because each control has a
178
To Next Page
Loading...
