One of the buttons must be available to use in conjunction
with the Command dials and the Control panel in order to see
and change the settings for bracketing. So, before you read
this tutorial on bracketing, either decide to use the default Fn
(FUNC.) button or mark your place here and go to one of the
following button assignment functions and choose the one
you want to use to start the bracketing process.
Here are the three Custom settings that you may configure for
Auto bracketing, in case you want to use the Fn (FUNC.)
button for something else. The assignment process for each of
these is covered in detail later in this chapter, under Section
Six – (f) Controls: Custom Settings f1 to f11:
▪ Assign Fn (FUNC.) button – Custom setting f5 (D300S)
or Custom setting f4 (D300)
▪ Assign preview button – Custom setting f6 (D300S) or
Custom setting f5 (D300)
▪ Assign AE-L/AF-L button – Custom setting f7 (D300S)
or Custom setting f6 (D300)
The following information assumes that the Fn (FUNC.)
button is assigned to BKT -Auto bracketing. If you have
chosen another button for Auto bracketing, you’ll need to use
your preferred button to turn bracketing on.
Exposure Bracketing (AE and Flash
Combination)
Here are the controls and steps to configure AE and flash
bracketing combinations (see Figure 4-55-Figure 4-58):
365
To Next Page
Loading...
