Figure 10-9. Screens to recover a White balance setting
from an image
2. Use the Multi Selector to scroll to the memory location
you want to set with the value from an image (see
Figure 10-9, image 1). You must select d-1–d-4 only.
You cannot use d-0 for this operation. Press the Multi
selector center button to select the memory location you
want to replace.
3. Scroll down to Select image and scroll to the right (see
Figure 10-9, image 2). It will be grayed out if there are
no images on your current memory card.
4. You will now see the Select image screen (see
Figure 10-9, image 3). Navigate through the available
images until you find the one you want to use for white
balance information.
5. Press the Multi selector center button and a small picture
of the image will appear in your selected White balance
memory location (see Figure 10-9, image 4).
692
To Next Page
Loading...
