EasyManua.ls Logo

Nintendo 2DS - Recharging

Nintendo 2DS
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Preparations
Preparations
22 23
Game Card Slot (page 39)
For loading Nintendo 3DS Game Cards, Nintendo DS Game Cards,
Nintendo DSi Game Cards and Nintendo DSi enhanced Game Cards.
Component Names and Functions
Wrist Strap Attachment
For attachment of a wrist strap
(sold separately).
Infrared Transceiver
Sends and receives signals for software
with infrared functionality.
Stylus Holder
Used to store the Nintendo 2DS stylus.
Note: Do not attempt to place anything
other than the Nintendo 2DS stylus
(FTR-004) into the stylus holder.
L Button
Battery Cover (page 76)
Can be removed to replace the Nintendo 3DS Battery Pack.
Note: Please refrain from removing unless it is absolutely necessary.
AC Adapter Connector
(page 23)
Allows connection of the Nintendo 3DS
AC adapter (WAP-002(UKV) / WAP-002(EUR)).
Outer Cameras
(page 32)
Used by software with camera
functionality. These two cameras allow
3D photographs / videos to be taken.
Note: 3D images cannot be viewed on
Nintendo 2DS.
R Button
Recharging
You must charge the battery pack before you use your Nintendo 2DS system
for the rst time.
Recharging
AC plug connectors
Recharge LED lit
(The LED will go out when
charging is complete.)
DC plug
(logo facing upwards)
Connect the DC connector plug to the Nintendo 2DS system
Note: Be sure the DC connector plug is the right way up before inserting it into the system.
Insert the AC adapter plug into a standard 220 – 240V AC plug socket
The recharge LED will light up when charging begins, and turn o when charging is nished. When charging has nished, remove the
AC adapter plug from the plug socket and remove the DC connector plug from the Nintendo 2DS system.
Note:
If you play a game while the system is recharging, the recharge LED may not always turn o once charging has completed.
This is not a malfunction.
To detach the system from the AC adapter, hold the system and the DC connector plug, not the cable, while you remove it.
About Charging
The system takes approximately 3 hours 30 minutes to fully recharge when o. Charging time may vary if the system is being used while charging,
or depending on the level of charge remaining in the battery.
Charge the system in an environment of 5 – 35°C. Attempting to charge the battery while the ambient temperature is outside this range may
degrade the battery and prevent it from charging. If the ambient temperature is low, the battery may not charge completely.
Battery life decreases slightly over time as the battery is continually used and recharged. After 500 recharges, battery life may be reduced to 70%
of the battery life at the time of purchase.
Make sure to charge the battery at least once every six months. Lithium-ion batteries can slowly lose their charge over time if they have not been
used for a while. If the system is not used for an extended period of time, the battery may become overdischarged and may be impossible to charge
when connecting the AC adapter.
If you feel the usage time has noticeably reduced, replace the battery pack. Replacement battery packs are sold separately (page 76). Please contact
Nintendo Customer Support for further information on where to purchase a replacement (pages 90 – 91).
1
2
Note: The illustration above shows the UK version of the AC adapter.

Other manuals for Nintendo 2DS

Related product manuals