www.nitronic.ch - 14 -
Nitronic AG
Mattenstrasse 11
CH – 2555 Bruegg Tel. +41 32 373 7070
Switzerland Fax +41 32 373 70
Programming
Processing Steps
The programmed steps (step 1, step 2 etc.) are processed in ascending order. The selection of
the process sequence is achieved by programming of the respective steps.
Standard process cycle Special process cycle
Ad-
van-
tages of the special process cycle
• The blade lifetime increases because the shielding is being cut only once.
• Clean cut because the short shield is supported by the dielectric and insulation.
• Clean cut edge of the dielectric because stripping is done as the last step; also partial strip can
be programmed to protect the conductor.
Disadvantage of the special process Cycle
• Soft dielectric may be distorted and bent by the centering jaws, at Step 3.
Only 3 of 9 possible steps are shown in this example.
To Next Page
Loading...