www.nitronic.ch - 40 -
Nitronic AG
Mattenstrasse 11
CH – 2555 Bruegg Tel. +41 32 373 7070
Switzerland Fax +41 32 373 70
Adjusting of the trigger contact
Turn off the machine and disconnect the mains cable.
• Remove safety cover (2) (Fig. 2, page 11).
• Remove the housing screws (31) and take off cover (17) (Fig. 2, page 11).
• Tilt the electronic part back
• Retract the release rod (41) and loosen the screws (42) of the drive element (43). The drive
element should now be easily movable on the release rod (Fig. 30).
• Shift drive element (43) on the release rod (41) forward by
approx. 5 mm (Fig. 31).
• Carefully pull the stripping head fully forward by hand.
Fig. 30. Loosen drive ele-
To Next Page
Loading...