www.nitronic.ch - 31 -
Nitronic AG
Mattenstrasse 11
CH – 2555 Bruegg Tel. +41 32 373 7070
Switzerland Fax +41 32 373 70
Program Step
Selecting and Entering
Select the diameter 3.0.
The blades together with the centralizers move
to the
previously set diameter, i.e. 3.00 mm.
• Push the two stripping blades carefully until their cutting
edges contact the adjusting pin (16) and slightly tighten
the set screws (10) of the stripping blades (12).
Program Step
Selecting and Entering
Fig. 12. Centering of the strip-
ping blades using the adjusting
pin
To Next Page
Loading...