Nitronic ST730T - Auxiliary Functions; Open Blades Prior to Pull-off (Wayback); Partial Strip (Par Strip)

www.nitronic.ch - 20 -
Nitronic AG
Mattenstrasse 11
CH – 2555 Bruegg Tel. +41 32 373 7070
Switzerland Fax +41 32 373 70
75
Auxiliary Functions
The following auxiliary functions can be used to optimize stripping quality and processing time.
1. Open blades prior to pull-off (Waybck)
You can program the machine as such that the stripping blades open a little (in diameter) before
the pull-off is carried out.
Advantage:
• Better stripping quality because the blades will not scrape the conductor during the pull-off cy-
cle.
• Increased blade lifetime.
The opening of the blades (wayback) can be programmed for each step.
Program Step Selecting and Entering
Select the wayback in the desired step, e.g. Step 2
and enter the blade opening value e.g. 0,20 mm.
0.2
- Enter
The wayback can be deleted at anytime.
Select the Wayback 0.20 in Step 2 and delete the
selected wayback value.
0.20 - Del
2. Partial Strip (Par Strip)
To protect the exposed center conductor or shielding, the auxiliary function „Partial Strip“ can be
selected for every step. The partial strip can be programmed in increments between 1 mm and
30 mm.
Program Step Selecting and Entering
Select the partial strip in the desired step e.g. Step 3
and enter the partial strip length, e.g. 5mm
5
- Enter
The partial strip value can also be deleted.
Select
The partial strip 5 mm in Step 3 and delete the
Selcted partial strip value.
5
-
Del