Nitronic ST730T - Basic Settings; Toggle Units Millimeter; Inch; Micro Coax Mode; Autobaud OFF

To Next Page

To Previous Page

www.nitronic.ch - 25 -

Nitronic AG

Mattenstrasse 11

CH – 2555 Bruegg Tel. +41 32 373 7070

Switzerland Fax +41 32 373 70

Basic settings

1.Toggle units Millimeter / Inch

To toggle the units on the Nitronic ST730T from mm to inch, proceed as listed below

Program Step

Selecting and Entering

Select the basic settings of the machine.

Select the desired unit Inch.

Rechtslauf.

2. Micro Coax Mode

Using the Micro Coax Mode for stripping small coaxial cables. The gripper jaw closing and the

stripping

processes will be adjusted.

To toggle the Nitronic ST730T on the Micro Coax Mode, proceed as listed below

Program Step

Selecting and Entering

Select the basic settings of the machine

Select the Micro Coax Mode.

3. Autobaud OFF

For special communication software.