Nitronic ST730T - Programming of (Step) in Graphic Mode

To Next Page

To Previous Page

www.nitronic.ch - 15 -

Nitronic AG

Mattenstrasse 11

CH – 2555 Bruegg Tel. +41 32 373 7070

Switzerland Fax +41 32 373 70

Programming of (Step) in graphic mode

To ensure a quick and speedy 3-step processing cycle is to be programmed as follows:

1. Turn the unit ON

Toggle the main switch to I

2. Allocate a program memory position

Program Step

Selecting and Entering

Select an empty memory position, e.g. Cab

le No.

Cable - 10 - Enter

3. Select graphic mode

Program Step

Anwahl

Select the graphic mode

4. Select 3 steps

Program Step

Selecting

Select +Step three times.