Nitronic ST730T - Page 3

www.nitronic.ch - 3 -
Nitronic AG
Mattenstrasse 11
CH – 2555 Bruegg Tel. +41 32 373 7070
Switzerland Fax +41 32 373 70
75
List of Programs ..................................................................................................... 17
List of Programs (Example) .................................................................................... 19
Auxiliary Functions ........................................................................................................... 20
1. Open blades prior to pull-off (Waybck) .............................................................. 20
2. Partial Strip (Par Strip) ....................................................................................... 20
3. Feed rate and rotation time (Feed und RTime) .................................................. 21
Blade feed rate (Feed) ........................................................................................... 21
Rotating time (RTime) ............................................................................................ 21
4. Rotation during pull-off (Rot) ................................................................... 21
5. Counter .............................................................................................................. 21
6. Memory access locking code (Code)................................................................. 22
7. Joining of multiple programs (Sequence) .......................................................... 22
8. Exchange of an Steps with an other Step (Swap Step) ...................................... 23
9. Copying of memory contents (Copy Cable) ........................................................ 23
10. Copying of Steps (Copy Step) ......................................................................... 24
Basic settings ................................................................................................................... 25
1.Toggle units Millimeter / Inch .............................................................................. 25
To toggle the units on the Nitronic ST730T from mm to inch, proceed as listed below 25
2. Micro Coax Mode ............................................................................................... 25
3. Autobaud OFF.................................................................................................... 25
4. RS232 ................................................................................................................ 26
5. Direction of rotation (Rotary Dir.) ....................................................................... 26
6. Touchscreen calibration (Calib. Touch) 26
7. Deleting of memory contents (Del. Memory) .................................................... 27
8. Calibration of the blades (Calib. Blades) ............................................................ 27
Maintenance ....................................................................................................................... 28
Service guidelines ............................................................................................................ 28
Replacing the stripping blades ......................................................................................... 28
Loosen wire catcher ............................................................................................... 28
Fig. 7. Loosen set screws ...................................................................................... 28
Fig. 8. Centering guide lever .................................................................................. 29
Fig. 9. Remove stripping blades ........................................................................... 29
Fig. 10. Push both stripping blades ................................................................... 29
Fig. 11. Inserting the adjusting pin ......................................................................... 30
Fig. 12. Centering of the stripping blades using the adjusting pin .......................... 31
Centering the centralizers ................................................................................................ 33