Replacing the Battery
IP390 Security Platform Installation Guide 71
Warning
Risk of explosion if battery is replaced by an incorrect type. Replace the battery only with the
same or equivalent type that the manufacturer recommends. Dispose of used batteries
according to the manufacturer's instructions.
Warning
Make certain to remove the power cord from the appliance before you proceed with any of
the following steps. Failure to do so could cause electric shock with burns or death resulting
for the user.
Caution
Make certain that you are properly grounded when you handle components internal to
the appliance to protect against electrostatic discharge damage to the appliance. Use
the grounding wrist strap included in the battery replacement kit.
To install the battery
1. Use Network Voyager or the CLI to halt the appliance.
To use Network Voyager to shut the appliance down, select
System > Configuration > Reboot or Shutdown > Halt.
To use the CLI to do this, enter halt at the prompt.
2. Loosen the two front panel retaining screws.
3. Loosen the two front panel retaining screws.
00525
IP390
Chassis tray assembly retaining screws
To Next Page
Loading...
Need help?
General
