7 Troubleshooting
102 IP560 Security Platform Installation Guide
Appliance locks up after you upgrade Nokia IPSO with a
console connection. No error messages appear, but the
appliance stops responding to console and network.
Problem During the upgrade process, some of the environment variables
might not have updated correctly.
Solution You can verify what the current boot manager settings are by
issuing a
printenv
command at the boot manager prompt, as shown in this
example:
Loading boot manager ..
BOOTMGR[0]> printenv
Bootmgr Revision: 3.3,base kernel=3.5.1-fcs1
02.12-2001-102644
autoboot: NO
bootwait: 5
boot-file:
boot-flags:
boot-device:
No referenced boot-file or boot-device appears.
Setting the boot manager to defaults causes the boot manager to determine
that no environment variables are set, and it responds by importing the
defaults from the binary file. To set the boot manager to defaults, issue the
set-defaults
command at the boot manager prompt as shown in this
example:
BOOTMGR> set-defaults
If you issue the printenv command again, the boot-file and boot-device entries
are present, as shown in this example:
To Next Page
Loading...
