4. Choose Testing → WLAN RX Tests or WLAN TX Tests. See the following figures.
WLAN TX BiP testing procedure in Phoenix
Context
Note: This is an alternative procedure to tune the WLAN TX. The other, recommended procedure is
described in chapter WLAN TX BiP testing procedure in Testing and Tuning Tool (page 3–72 ) .
Note: No external measurement equipment is required as the calibration is completely handled
internally. RF cable and adapter losses do not need to be taken into account while WLAN TX tuning
is proceeded.
WLAN TX has been BiP (Build in Prduction line testing) tuned correctly in production. There is no reason to
do re-calibration unless the Bob1.0M-b (N6300) is changed or memory (D3000) is corrupted.
WLAN TX can be tuned automatically with Testing and Tuning Tool. It performs calibrations and tunings of
WLAN TX. The results are displayed and logged in a result file, if initiated.
Steps
1. Place the phone in the flash adapter or connect data cable to phone.
2. Start
Phoenix
service software.
3. Choose File → Scan Product.
4. Choose Tuning → WLAN_TX_TUNING. See the following figure.
RM-596
BB Troubleshooting and Manual Tuning Guide
Issue 2 COMPANY CONFIDENTIAL Page 3 – 71
Copyright © 2010 Nokia. All rights reserved.
To Next Page
Loading...
