8
Introduction
Introduction
The Bluetooth-enabled WristOx
2
, Model 3150, is a small, wrist-worn device that displays,
measures, and stores patient SpO
2
and pulse rate data. The device includes a Bluetooth
radio with a range (spherical radius) of approximately 100 meters (328 feet).
The device ships ready to use in Spot Check turn on mode. In Spot Check turn on mode,
inserting a finger in the sensor automatically turns the device on. Approximately 10
seconds after the finger is removed, the device enters Standby mode.
Advanced memory and programming features are available with Nonin’s nVISION
®
software (version 6.3 or greater). See the “nVISION Software” section to learn more about
using the device with nVISION.
Unpacking the WristOx
2
, Model 3150
The WristOx
2
, Model 3150, standard or starter kit includes the items listed below. Once the
shipping carton is unpacked, verify these items were received. Contact the carrier
immediately if the shipping carton is damaged.
Standard Kit
• Model 3150, WristOx
2
Pulse Oximeter
• Model 8000SM-WO2, reusable soft sensor
• 3 two-piece wrist bands, 1 each of the following:
• 6 in. (15 cm)
• 8 in. (20 cm)
• 10 in. (25 cm)
• 2 AAA (1.5 volt) alkaline batteries
• Operator’s manual (CD)
• USB driver software (on operator’s manual CD) – required to use the PC USB interface cable
Starter Kit
A starter kit is required to configure the device and download data to a PC. The starter kit
consists of the standard kit, plus:
• 9 pack of two-piece wrist bands, 3 each of the following:
• 6 in. (15 cm)
• 8 in. (20 cm)
• 10 in. (25 cm)
• nVISION SpO
2
data management software (CD)
• PC USB interface cable
To Next Page
Loading...
