Nonin 3150 - Thread and Tighten Two-Piece Wrist Band; Fasten Two-Piece Wrist Band

20
Using the WristOx2, Model 3150
2. Place the device on the back of the patient’s arm.
3. Thread the rounded end of the adjustable strap through the plastic ring on the ring
stra
p. Pull the adjustable strap through the plastic ring until the device fits comfortably
on the wrist (figure 14).
Fastener
Plastic
Ring
Figure 14: Thread and Tighten Two-Piece Wrist Band
4. Fold the adjustable strap back over the plastic ring and attach the fastener to the
adjust
able strap (figure 15).
Figure 15: Fasten Two-Piece Wrist Band
5. Attach the sensor if it is not already connected (see “Att
aching the Sensor”).
6. Apply the sensor to the patient (figure 16). Refer
to the sensor Instructions for Use for
proper sensor application sites and sensor application cautions and warnings.