12
Using the WristOx2, Model 3150
Using the WristOx
2
, Model 3150
Installing Batteries
1. Open the battery compartment by sliding the battery door off the back of the
device (figure 3).
Figure 3: Remove Battery Door
2. Insert 2 new AAA alkaline batteries (figure 4). Battery orient
ation is shown
inside the battery compartment.
Figure 4: Insert Batteries
3. Replace battery door by sliding it back into place.
4. Inserting batteries does not turn the device on. In Spot Check mode, the device
turns on when a finger is inserted in the sensor.
WARNING: Do not use the device when alarms are required.
W
ARNING: The USB cable must be unplugged from the device before replacing
batteries.
NOTE: When batteries are removed, the device maintains the time and date for up to
30 seconds. If replacing batteries takes more than 30 seconds, or if the battery level is
at or below the critical level, the operation mode reverts to Spot Check mode. Use
nVISION software to reset the clock and change the operation mode.
To Next Page
Loading...
