Nonin 3150 - Wrist Straps; Ring Strap Description

13
Using the WristOx2, Model 3150
Wrist Straps
The WristOx
2
, Model 3150, is designed to be applied to the patient’s wrist using a two-
piece wrist band. The two-piece wrist band consists of a ring strap and an adjustable strap.
For pediatrics and petite adults, the device may b
e applied using a single adjustable strap.
The single adjustable strap is the longer of the two straps in the two-piece wrist band
package.
Straps have hook and loop fasteners on one side. The other side has a smooth, woven
fabric. Wh
en the straps are attached to the device, the woven side should touch the
patient’s skin.
This section contains descriptions of the straps and instructions for attaching the straps to
the de
vice. See the “Patient Application” section for instructions on how to apply the device
to the patient.
Ring Strap Description
One end of the ring strap has a plastic ring. The square end has a hook and loop fastener
(figure 5).
The square end attaches to the strap bar at the top of the device, by the sensor port
(see “Attach Ring Strap to Device”).
Attach this end to strap
bar by sensor port
Fastener
Hook and Loop Side
Woven Side
Figure 5: Ring Strap
NOTE: A wrist strap has a maximum of 10 uses before replacement is required.