Nordmann AT4 - Page 31

31
– Operation with timer controlled capacity limitation:
Select “Power Limit” in the settings menu, then press the <Set> key.
Select “Timer”, then press the <Set> key. In the upcoming modication dialogue activate the timer
function and conrm the setting with the <Set> key.
If the timer is activated, up to eight switching points (events 1  8) with different capacity limits can
be dened. Each switching point is dened by a weekday or weekday range, the switching point
and the capacity limitation in % of the maximum capacity.
Conguration notes:
– the settings of an event remain active up to the next event.
– the software does not check the plausibility of the timer settings. Therefore, make sure your
settings make sense.
– the On/Off timer (see chapter 5.4.7) overrides the capacity limit timer.
Settings
SC-System :Set
Power Limit :Set
On/O Timer :Set
Cylinder :6564
Water Manag.:Set
Esc Set
Power Limit
Power Limit :50%rH
Timer :O
Esc Set
Power Limit
Event 1 :06:00
Event 2 :18:00
Event 3 :--:--
Timer :On
Event 4 :--:--
Esc Set
Power Limit
Event 1 :06:00
Event 2 :18:00
Event 3 :--:--
Timer :On
Event 4 :--:--
Esc Set
Event 2
Time :18:00
Power Limit :100%
Weekday :Mo-Fr
Esc Set
Event 2
Time :18:00
Power Limit :100%
Weekday :Mo-Fr
Esc Set
Event 2
Time :18:00
Power Limit :100%
Weekday :Mo-Fr
Esc Set
Timer
O
On
On
Esc Set
Weekday
O
Mo-Fr
Mo-Sa
Mo-Fr
Mo-Su
Esc Set
Power Limit
100 %
100 %
Esc Set
Time
18:00
18:00
Esc Set