Nordmann AT4 - Setting The Operation Time Of The Sc-Pump; Configuring the Capacity Limitation

30
Settings
SC-System :Set
Power Limit :Set
On/O Timer :Set
Cylinder :6564
Water Manag.:Set
Esc Set
Power Limit
Power Limit :100%
Timer :O
Esc Set
Power Limit
Power Limit :100%
Timer :O
Esc Set
Power Limit
100 %
100 %
Esc Set
5.4.5.2 Setting the operation time of the SC-Pump
Select “On-Time” in the SCSystem settings menu, then press the <Set> key.
In the upcoming modication dialogue set the operating time of the SCPump per hour in minutes.
Factory setting: 20 minutes
Setting range: 20 ... 60 minutes
5.4.6 Conguringthecapacitylimitation
With the parameters in the “Power Limit” submenu you determine whether the Nordmann AT4 is to be
operated with a x capacity limitation (factory setting) or whether it is to be operated with a timer con
trolled capacity limitation.
– Operation with x capacity limitation:
Select “Power Limit” in the settings menu, then press the <Set> key. Let the timer deactivated (Off)
or deactivate the timer if necessary.
Select “Power Limit”, then press the <Set> key. In the upcoming modication dialogue set the value
for the x capacity limitation in % of the maximum capacity.
Factory setting: 100 %
Setting range: 30...100 %
SC-System
On-Time :20min
SC-Pumpe :On
Esc Set
Settings
Cylinder :6564
SC-System :Set
Power Limit :Set
Controls :Set
On/O Timer :Set
Esc Set
On-Time
20 min
20 min
Esc Set