5.4.8.3 Setting the operating mode for standby operation
– Idle only operation
In this operating mode the cylinder is not emptied in standby operation.
Select “Idle Operat.” in the water management settings submenu, then press the <Set> key. In the
upcoming submenu select “Idle Mode”, then press the <Set> key.
In the upcoming modication dialogue set Idle Mode to “IdleOnly”, then press the <Set> key.
– Standby operation with partial or complete draining of the steam cylinder
In this operating mode the cylinder is partly or fully drained after a certain time in standby opera
tion.
Select “Idle Operat.” in the water management settings submenu, then press the <Set> key. In the
upcoming Idle operation submenu set the parameters for standby operation with partial or complete
draining of the steam cylinder.
Settings:
• “Idle Mode”: “Drain”
• “Drain Mode”: “Full” (complete draining of the cylinder) or “Partial” (cylinder is drained so
far that the water does not touch the electrodes any longer)
Important: with outdoor operation it is mandatory to set the drain mode
to “Full”.
Settings
On/O Timer :Set
Water Manag.:Set
Date :11-08-31
Power Limit :Set
Time :12:00
Esc Set
Water Manag.
Drain Factor:1.0
Idle Operat.:Set
Force Drain :On
Conductivity:>125µS
Force Delay :72h
Esc Set
Idle Operat.
Drain Mode :Full
Drain Delay :72h
Idle Mode :Drain
Esc Set
Idle Operat.
Idle Mode :IdleOnly
Esc Set
Idle Mode
IdleOnly
Drain
KeepWarm
IdleOnly
A.Freeze
Esc Set
Settings
On/O Timer :Set
Water Manag.:Set
Date :11-08-31
Power Limit :Set
Time :12:00
Esc Set
Water Manag.
Drain Factor:1.0
Idle Operat.:Set
Force Drain :On
Conductivity:>125µS
Force Delay :72h
Esc Set
Idle Operat.
Idle Mode :IdleOnly
Esc Set
Idle Operat.
Drain Mode :Full
Drain Delay :72h
Idle Mode :Drain
Esc Set
Idle Operat.
Drain Mode :Full
Drain Delay :72h
Idle Mode :Drain
Esc Set
Idle Operat.
Drain Mode :Full
Drain Delay :72h
Idle Mode :Drain
Esc Set
Idle Mode
IdleOnly
Drain
KeepWarm
Drain
A.Freeze
Esc Set
Drain Mode
Partial
Full
Full
Esc Set
Drain Delay
72 h
72 h
Esc Set