Parts
6-4
Part 1105779-04
E 2014 Nordson Corporation
Console Parts
Figures 6-1 through 6-8 show the replaceable parts for both master and
slave consoles. Contact your Nordson representative or Nordson Customer
Support for help in obtaining unlisted parts.
Refer to Section 7 for pneumatic and electrical diagrams.
See Figures 6-1 and 6-4 for the parts listed in this table:
Item Part Description Quantity Note
1 1034033 SCREW, pan head, recessed, M6 x 10, zinc 24
2 983128 WASHER, lock, internal, M6, steel, zinc 16
3 1036657 MODULE, digital airflow control AR A
4 1073381 PLATE, blank, enclosure AR A
5 −−−−−− GASKET, module, digital airflow control AR A
6 982802 SCREW, socket, M5 x 70, black AR A
7 1033878 REGULATOR, rolling diaphragm, 0−120,
1
/
2
in. AR A, B
8 972240 CONNECTOR, male, elbow, 12 mm tube x
1
/
2
in. AR A
9 1034000 FITTING,
1
/
2
in. RPT x (4) 10 mm tube AR A
10 148256 PLUG, 10 mm tubing AR A
11 −−−−−− WASHER, flat, M8, zinc 4
12 −−−−−− WASHER, lock, split, M8, zinc 4
13 −−−−−− SCREW, button head, socket, M8 x 12 4
14 1023877 PCA, dual gun driver, iControl AR A
14A −−−−−− JUMPER, gun ID, odd number AR D
15 1031501 RECEPTACLE, 8 position, gun, 70 in. AR A, C
15A 1023695 SEAL, bulkhead,
7
/
8
−16 thread AR C
NOTE A: Quantities of noted parts depends on system configuration and console type.
B: New regulators must be calibrated using iFlow air flow verification kit. Refer to Miscellaneous Kits on
page 6-14.
C: Use to cap unused receptacles. One seal is shipped with each console. See Figure 6-4.
D: Use to prevent fault LED from lighting when odd number of guns are connected. Plug into gun card
receptacle in place of receptacle harness for unused receptacle. One jumper is shipped with each
console.
AR: As Required
Continued...
To Next Page
Loading...
