Installation
3-27
Part 1105779-04
E 2014 Nordson Corporation
Adding a Slave Console to an Existing System
Adding a slave console increases the system capacity to 32 guns.
1. Connect the slave console power cable and ground cable as described
on page 3-6.
2. Connect the slave console to the master console with the provided
network cable. Connect the network cable from the CAN OUT terminal
block on the master console backplane to the CAN AUX terminal block
on the slave console backplane. Route the cable through dust-tight
strain reliefs. Refer to page 3-1.
3. Set the slave console network address to console 2 as described on
page 3-2.
4. Set the slave console iFlow module network addresses as described on
page 3-3.
5. Connect the compressed air supply to the slave console as described
on page 3-21.
6. Connect the spray gun cables and the flow-rate, atomizing, and gun air
tubing to the slave console as described on page 3-20.
7. Turn on the console and configure the iControl program to add the new
guns to the system. Refer to Gun Configuration in the iControl Operator
Interface manual.
8. Set pickoff points for the new guns as described in the Configuration
section of the iControl Operator Interface manual.
9. Set up presets for the new guns as described in the Preset Setup
section of the iControl Operator Interface manual.
Installing Optional Nozzle Purge Kits
Nozzle purge kits are used only with Versa-Spray guns equipped with
optional purge adapters. Nozzle purge uses high-pressure compressed air,
typically at line pressure, to purge the spray gun nozzles.
The nozzle purge kits are field-installed in the iControl consoles,
pneumatically connected to the console air manifold and spray guns, and
electrically connected to the P5 receptacle on the backplane.
Installation instructions are shipped with the nozzle purge kits.
To Next Page
Loading...
