Repair
5-5
Part 1105779-04
E 2014 Nordson Corporation
Adding Guns
If the console has an odd number of guns you can add another gun without
adding another gun control card. If your console has an even number of
guns less than 16, you can add more guns by installing a new gun control
card in an unused slot. Refer to System Upgrades in the Installation section
for more information on adding guns to an existing system.
For either scenario, you must open the Guns and Consoles configuration
screen, increase the number of guns, and reboot the system before the new
guns will be recognized.
NOTE: Cards are installed in the card cage from left to right. Guns are
numbered from left to right and bottom to top.
Replacing A Card
If you are replacing an existing card, turn off the booth exhaust fan first, then
replace the card. When you turn on the booth exhaust fan, the green
watchdog LED should blink. Since the card ID has changed the red fault
LED on the card will light and a fault message will appear on the Alarm
screen. To reset the fault LED, open the Alarm screen and touch the Clear
All Faults button.
2
3
4
1
6
5
2 4 6 8 10 12 14 16
1 3 5 7 9 11 13 15
Gun Order in Card Cage
Figure 5-2 Gun Control Card Replacement
1. Card cage (slot 1)
2. Gun control card
3. Gun 2 connector
4. Gun 1 connector
5. Locking tab
6. Backplane
To Next Page
Loading...
