Repair
5-6
Part 1105779-04
E 2014 Nordson Corporation
iControl PC Replacement
NOTE: Identify if the PC being replaced is an obsoleted PC or a new PC. If
the PC being replaced is a new PC, only a direct replacement is needed. If
the PC is an obsoleted model, then use the following information for
replacement. (Refer to the Parts section for identifying the new PC model
from the obsoleted model.)
NOTE: Record the current software versions before shutting down the PC.
WARNING: Shut off power to the console and PC before removing the PC.
Failure to observe this warning could result in personal injury or even death.
Use the Touch Screen PC Kit to replace obsoleted PC models. The kit
includes the PC with new ribbon cable, programmed memory, and Compact
Flash memory.
The Compact Flash memory from the obsolete PC unit can be used in the
new PC, and then the new Compact Flash can be used to make a backup.
The obsolete PC used eight M6 screws to mount to the panel. Once
removed, these screws can be discarded. The new PC model has eight M6
studs that mount onto the iControl panel using eight M6 nuts.
See Figure 5-3. The Compact Flash adapter along with the adapter cable
and power supply cable are no longer needed.
A longer ribbon cable is provided with the PC to connect the PC to the
digital input module.
Complete PC connections before powering up the new PC.
Adapter
Styles
Digital Input
Module
PC
PC
Digital Input
Module
Obsolete PC New PC
Figure 5-3 Obsolete and New iControl PC
To Next Page
Loading...
