Nordson iControl - Ethernet Network Connections Setup

Installation
3-15
Part 1105779-04
E 2014 Nordson Corporation
Ethernet Network Connections
The Ethernet network allows the iControl system to communicate with
remote Ethernet devices such as the in/out positioner or reciprocator
controllers and the Ethernet couplers that receive signals from the analog
scanner controllers.
NOTE: Do not connect any device to this network that is not approved by
Nordson Finishing Technical Support or Engineering.
The required field connections are shown in Figure 3-9, along with the
connections required for sharing the in/out positioner scanner with a 2nd
booth. Refer to Section 7 for junction box and control panel drawings.
3/4-in. Conduit
w/25-Conductor,
CAN, and
Ethernet Cables
Network Interface Box
Ethernet Switch
In/Out Positioner / Reciprocator
Control Panels
FieldBus
Controllers
FieldBus
Coupler
In/Out Positioner
Scanner J-Box
(2nd Booth Option)
Ethernet Switch
Ethernet
PCI Card
FieldBus Coupler
2nd Booth
Network Interface Box
Ethernet Switch
2nd Booth Option
In/Out Positioner
Scanner J-Box
NOTE: Maximum Ethernet cable
length is 100 meters (328 ft). If
longer, an Ethernet switch must
be installed in the cable run.
Ethernet
Cables
Ethernet
Patch
Cable
Termination
Module
Ethernet
Patch
Cable
Termination
Module
Ethernet
Patch
Cables
Termination
Modules
Ethernet
Cable
Ethernet
Cable
Ethernet Cable
Ethernet
Patch
Cable
Connection made
to ETH1
iControl Computer
shown with back
upper cover
removed
(on Door)
Figure 3-9 Remote I/O Network Equipment and Connections (with Connections for 2nd Booth Option)