Installation
3-23
Part 1105779-04
E 2014 Nordson Corporation
The card adapter is mounted on the inside of the master console door. The
inner card (1) is the data card; the outer card (2) is the program card.
NOTE: To remove a card, simply pull it out of the slot.
1
2
Figure 3-14 User Data and Program Card Locations
1. Data card
2. Program card
The iControl program can be updated by installing a new program card.
In addition to the configuration data, up to 255 presets per gun can be
stored on one data card. Additional cards will provide you with a virtually
unlimited number of presets. To back up a data card use the Data Backup
function. This copies the data to a blank card. Refer to Data Backup in the
iControl Operator Interface manual for instructions.
NOTE: Not all CompactFlash cards are the same. If you purchase
additional cards, make sure they are from a Nordson-approved
manufacturer and are 128 Mb or greater. For approved cards, refer to
Specifications in the Description section of this manual or contact your
Nordson controls engineer or Nordson Technical Support.
Touch Screen Calibration
The touch screen is calibrated at the factory before the system is shipped.
The touch screen calibration values are stored on the program card. If you
install a new program card that has never been used before, there will be no
calibration file on the card. The system will automatically start the
calibration procedure.
Follow the calibration instructions on the screen exactly, using your finger to
touch the targets. When you have completed the calibration procedure,
touch the iControl button to start the iControl software.
Refer to Troubleshooting for a complete description of the calibration
procedure and instructions on calibration.
To Next Page
Loading...
