Installation
3-12
Part 1105779-04
E 2014 Nordson Corporation
Scanner Cable Connections
See Figure 3-7. The photoeye junction box and scanner junction boxes are
shipped with the scanner cables pre-wired to the junction boxes. The
scanner controllers are programmed at the factory according to the system
order specifications. Refer to your system plan views when locating the part
ID stand and scanners or photoeyes. The scanners must be mounted with
the cable ends oriented as shown.
Discrete Scanner Connections
S Single Zone Scanner: SCNR1 cables to scanner.
S Dual Zone Scanners: SCNR1 cables to upper scanner, SCNR2 cables
to lower scanner.
S Part ID Scanner and Zone Scanner: SCNR1 cables to zone scanner,
SCNR2 cables to Part ID scanner.
NOTE: The part ID scanner or photoeyes must be located so that the
iControl system receives the part ID before the leading edge of the part
breaks the zone scanners or photoeyes.
To Next Page
Loading...
