Installation
3-24
Part 1105779-04
E 2014 Nordson Corporation
System Upgrades
iControl systems can be upgraded by:
S adding additional guns to an existing console
S adding a slave console
S adding purge modules to a console used with Versa-Spray guns
S installing a new program flash card with updated software.
Certain upgrades require updates to the gun control card and iFlow module
firmware. These upgrades should only be done by a Nordson
representative.
Adding Guns to Existing iControl Console
Master and slave consoles are sold configured for 4, 6, 8, 10, 12, 14, or 16
guns. If your consoles were configured for less than 16 guns, additional
guns can be added by ordering and installing the required parts listed
below.
For each new gun added, use the requirements listed below to determine
the components needed. The sum of the parts required for each gun
equals the total parts required.
For example: For 2 guns added, determine the parts required for the first
gun, then assume the first gun has been added and determine the parts
required for the second gun.
To Next Page
Loading...
