Nordson iControl - Safety Labels Identification

Table of Contents
ii
Part 1105779-04
E 2014 Nordson Corporation
Installation 3-1.............................................
Introduction 3-1.............................................
CAN Network Connections 3-1...............................
Console CAN Network Address and Termination Settings 3-2..
iFlow Module Dipswitch Settings 3-3........................
Power, Ground, and Relay Connections 3-4....................
iControl Console Power Cable Connections 3-5..............
Conveyor Interlock and Remote Lockout Relay Connections 3-6
Grounding 3-7...........................................
PE (Protective Earth) Grounding 3-7......................
Electrostatic Grounding 3-7..............................
Gun Current Path 3-8...................................
ESD Ground Procedures and Equipment 3-9..............
Encoder, Photoeye, and Scanner Connections 3-9..............
25-Conductor Cable Connections 3-10........................
Switching Inputs to Sourcing 3-11..........................
Conveyor Encoder Connections 3-11.........................
Photoeye Connections 3-11.................................
Junction Box and Control Panel Power Requirements 3-11......
Scanner Cable Connections 3-12............................
Discrete Scanner Connections 3-12........................
Analog Scanner Connections 3-13.........................
Customer-Supplied Part ID System Connections 3-14..........
Ethernet Network Connections 3-15............................
iControl Console to Network Interface Box 3-16................
Ethernet Switch to Ethernet Devices 3-16.....................
MAC Addresses 3-16....................................
Connecting Termination Modules to Ethernet Cables 3-17.......
Ethernet Termination Standards 3-19.........................
Gun Cable Connections 3-20..................................
Odd Number of Guns 3-20..................................
Pneumatic Connections 3-21..................................
Supply Air Requirements 3-21...............................
Gun and Pump Air Connections 3-21.........................
Program and User Data Cards 3-22............................
Touch Screen Calibration 3-23.................................
System Upgrades 3-24.......................................
Adding Guns to Existing iControl Console 3-24................
Requirements to Add One Gun 3-25.......................
Procedure: 3-25.........................................
Adding a Slave Console to an Existing System 3-27............
Installing Optional Nozzle Purge Kits 3-27....................