Troubleshooting
6-10
Part 1124631_01
E 2015 Nordson Corporation
System Outputs
There are three system outputs that provide system status:
S Ready
An active output indicates that the pattern controller is ready for you
to run the line and produce products. The Ready output is not
affected by Alerts or Standby.
S Alert
An active output indicates that an Alert condition exists. Alert
conditions do not normally prevent you from producing products, but
should be investigated as soon as possible.
S Fault/Machine Stop
The SPDT (Single Pole Double Throw) dry contact output is activated
while a Fault condition exists.
Refer to the System Status Summary Chart for an details.
NOTES:
Refer to the Internal Wiring Details in Installation, Section 3 for
instructions on how to connect the system outputs.
Refer to the System Settings in Using the Menus, Section 5 for
instructions on how to change the polarity of the system outputs.
To Next Page
Loading...
