Installation
3-3
Part 1124631_01
E 2015 Nordson Corporation
Mount the Pattern Controller
1. Locate the following components required for mounting the pattern
controller.
1
2
3
Figure 3-2 Mounting components
1. Back panel
2. Mounting slot
3. Mounting plate
2. Loosen the socket head mounting screw from the pattern controller to
remove the mounting plate. Retain the mounting screw for re-installing
the mounting plate to the pattern controller.
1
Figure 3-3 Mounting the pattern controller
1. One M5 Socket head screw
To Next Page
Loading...
