TheUserInterface
4-33
Part 1124631_01
E 2015 Nordson Corporation
Continuous Pattern
This pattern type provides continuous adhesive application above a preset
line spee d. When this pattern is selected, the applicator outputs remain open
until the production line slows below the preset stop speed. With continuous
gluing no pattern is programmed and no trigger signal is required unless cut
gap* feature is used.
Assign the start and stop speed for the continuous bead.
1
4
5
3
6
7
8
9
11
10
2
10
Figure 4-29 Components for setting dot patterns
1. Continuous pattern
2. Gap length
3. Current applicator
4. Pattern display
5. Delay length before gap
6. Delay length increment tool
7. Delay length value
8. Units used
9. Panel s wipe indicator
10. Gap length value
11. Gap length increment tool
12. Product length
* Cut gap is an optional feature of continuous patterns.
- To set this feature, program an adhesive free gap by using the gap
delay and gap length.
- To disable this feature, program the gap length value to 0.0 mm.
To Next Page
Loading...
