Nordson Spectra 30 - Before Setting Up Spectra 30

Installation
3-9
Part 1124631_01
E 2015 Nordson Corporation
Before Setting Up Spectra 30
WARNING! Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Before setting up the pattern controller make sure of the following:
1. Pattern controller cover removed in step 1 under Connect Spectra 30
given earlier is re-installed.
2. Pattern controller components are connected.
3. Pattern controller power cable is connected to a grounded outlet.
4. Pattern controller switch is turned on.
Figure 3-10 Main Switch
location