x
Installation
3-4
Part 1124631_01
E 2015 Nordson Corporation
Mount the Pattern Controller (contd)
3. Slide the mounting plate out from the mount ing slot. See Figure 3-4.
4. Mount the mounting plate on a rigid support (e.g. wall or post) to prevent
external vibration.
5. Slide pattern controller into the mounting plate.
6. Secure the mounting plate by installing the screws provided in the
ship-with kit. Refer to Parts section for the ship-with kit part number.
7. Position the pattern controller and slide it into the installed mounting
plate.
8. Using the socket head mounting screw removed in step 2 secure the
pattern controller to the mounting plate.
Figure 3-4 Removing the
mounting plate
Attach the Quick Reference Guide
The Quick Reference Guide included in the ship-with kit provides an
overview of the user interface and common pattern generation tasks.
Slide the spiral bound side of the Quick Reference Guide to the two hooks on
either side of the top panel of the pattern controller.
To Next Page
Loading...
