Installation
3-5
Part 1124631_01
E 2015 Nordson Corporation
Connecting the Spectra 30
WARNING! Equipment must be properly grounded and fused according to
its rated current consumption (see ID plate). Failure to follow the safet y
procedures can result in serious injury.
1. Remove the pattern controller cover by loosening the four M5 captive
screws to access the internal boards.
Figure 3-5 Pattern controller cover removal
2. Routeallthecablesthroughtheconduitslocatedonthebasepanelof
the pattern controller, see Figure 3-6.
Refer to the Wiring Diagram for connecting the device specific cables to
theproperlocationonthecorrespondingboards.
Figure 3-6 Routing the cables
To Next Page
Loading...
