Installation
3-1
Part 1124631_01
E 2015 Nordson Corporation
Section 3
Installation
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
WARNING! Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Mounting the Spectra 30
Equipment and production line configuration may dictate a variation in the
mounting options described in this section. Regardless of the mounting
method used, refer to Guidelines.
Unpack the Pattern Controller
1. Carefully unpack the pattern controller. Exercise care to prevent
equipment damage during unpacking.
2. Inspect for any damage that may have occurred during shipping. Report
any damage to your Nordson representative.
Guidelines
S Position the pattern controller as close as possible to the parent machine
or production line.
S Mount the pattern controller vertically on the wall or post.
S Ensure that the mounting location provides sufficient clearance around
the bottom of the pattern controller to allow room for cable entry.
To Next Page
Loading...
