Nordson Spectra 30 - Initial Setup and Home Screen

TheUserInterface
4-3
Part 1124631_01
E 2015 Nordson Corporation
Starting the Spectra 30
When you start the pattern controller f or the first t ime a Setup Wizard
appears,whichservesasaguidethrough the entire setup process. On every
subsequent power up the Splash Screen appears followed by the Home
Screen.
Setup Wizard
For a screen-by-screen guide refer to the Installation Guide.
The sequence of the Setup Wizard are as follows:
Button Menu Screens Function
Language
Selection
Select from any of the language
options by pressing the
corresponding button.
For more information refer to
Language in System Setup in
Using the Menus, Section 5.
Component
Selection
Select from the pre-programmed
list of applicators.
For more information refer to
Applicator Channel Settings
given later in this section. Also
refer to Components in System
Setup in Using the Menus,
Section 5.
Encoder Selection Select the e ncoder type from the
available selections.
For more information refer to
Encoder in System Setup in
Using the Menus, Section 5.
Units and Scale Set Units and Scale for pattern
programming by pressing the
corresponding button to either of
the following selections:
S Milliseconds to set the
patterns in time only
S Millimeter or inch to set the
patterns in distance
For more information refer to
Units and Scale in System Setup
in Using the Menus, Section 5.
Continued...