Overview
2-4
Part 1124631_01
E 2015 Nordson Corporation
Comparison Table
The following table compares a pattern controller with or without the add-on
features.
Add-on Options
WITH Add-on F eatures
(Software Licences Obtained)
WITHOUT Add-on Features
(Software Licences NOT Obtained)
Encoder Time, quadrature and single encoder
types are available.
Time is the only source available.
Power to the encoder is enabled. Powertotheencoderisnotenabled.
Current and encoder pulses are
detected.
Encoder is not detected.
Line speed is computed and scaled
based on the encoder type and scale
value.
Line speed is constant.
(Unscaled, the line speed is 1 ms [1 mm
at 60 m/min]).
Encoder screen available. Encoder screen is not available.
Enable auto type and direction detection
during commissioning.
No auto type and direction detection.
Encoder icon is displayed and can be
touched.
Encoder icon is not visible.
Encoder related alerts and faults
enabled.
No encoder related alerts and faults.
Pressure/Run-up
Run-up output changes based on the
curve defined by the settings.
Run-up does not change.
Output is powered 0 - 10V and
4-20mA.
Output set to 0 V.
Run-up icon is displayed and can be
touched.
Run-up icon is not visible.
Run-up related alerts and faults enabled. No run-up related alerts and faults.
Remote Recall
Remote Recall check box is displayed
and can be touched.
Remote Recall check box is grayed out
and disabled.
Remote recipes are re-callable. No action for changes to inputs.
Alerts enabled when a recipe is loaded. No remote recipe alerts or faults.
Extra Features Three additional pattern features are
available: Random Dotted, Autodot, and
Continuous
Includes other added features.
No additional pattern types or added
features are available.
To Next Page
Loading...
