TheUserInterface
4-39
Part 1124631_01
E 2015 Nordson Corporation
Use the following components to assign or modify the trigger settings:
SeeFigure4-32forthetriggerscreencomponents.
Tap Action
(Item 1 in
Figure 4-32)
Tap to select the next trigger.
(Item 2 in
Figure 4-32)
Select this setting to determine the
Trigger Polarity (light on or dark on) of
the trigger (1 - 4 ).
(Item 3 in
Figure 4-32)
100
Select Masking Distance when the
products contain holes or have cutouts.
This se tting is used to lock the trigger for
a predetermined distance.
(Item 4 in
Figure 4-32)
Select Palletize Settings for
programming the number of consecutive
products that will receive adhesive and
the number of consecutive products that
will be skipped before pattern generation
starts.
NOTE: The Product Skip function
operates only on one of the triggers. The
system automatically selects the first
active trigger for the skip function. Other
triggers continue to operate normally
without the skip function. The Product
Skip function in the Trigger Settings
screen appears only when the first active
trigger is selected.
NOTE: Palletize settings will not be
available if the Product Skip setting is
not selected on the Additional Machine
Settings screen. Refer to Additional
Machine Settings in System Setup in
Using the Menus, Section 5.
To Next Page
Loading...
