Using the Menus
5-5
Part 1124631_01
E 2015 Nordson Corporation
Purge
Select Purge for hot melt adhesives. This mode removes trapped air or
material from the adhesive applicator or nozzle, or relieves system pressure
when the applicator is turned on.
1. Hold a specific applicator button for purging.
2. Release the applicator button to stop purging.
Hammer
Select Hammer to allow the applicator output to actuate rapidly.
1. Hold a specific applicator button for hammering.
2. Release the applicator button to stop hammering.
Flush
Select Flush to open one or more applicators for an extended period.
1. Tap the applicator button to turn on a specific applicator. Multiple
applicators may be flushed by tapping specific buttons.
2. Tap the applicator button again to stop f lushing.
NOTE: All purge, flush, and hammer functions stop when leaving this
screen.
To Next Page
Loading...
