Notifier AFP-400 - Central or Remote Station Fire Alarm System

AFP-300/AFP-400 Installation PN 50253:C1 05/22/97 5-1
$SSOLFDWLRQV
$SSOLFDWLRQV2YHUYLHZ
Table 5-1 contains an index to sections and topics covered in Section 5:
7DEOH  $)3$)3 $SSOLFDWLRQV
Section Covers the following topics
"Central or Remote Station
Fire Alarm System" on page
5-2
Installing and configuring a UDACT with the control panel.
"Auxiliary Fire Alarm
System" on page 5-3
How to wire for an Auxiliary Fire Alarm System (Municipal Box
connected to a 4XTM).
"NFPA 72-1993 Remote
Station Fire Alarm System"
on page 5-4
How to wire a NFPA 72-1993 Remote Station Fire Alarm System
(Fire•Lite RS82 Remote Station Receiver).
"NFPA 72-1993 Proprietary
Fire Alarm Systems" on page
5-5
How to configure a control panel to automatically transmit General
Alarm, General Trouble, and General Supervisory signals, and will
receive Acknowledge, Silence, and Reset commands automatically from
the AM2020/AFP1010.
"Network Interface Board
(NIB-96)" on page 5-6
How to connect an NIB-96 to a control panel, including SLC and
EIA-485 Connections.
"Using the XP Transponder
with the AFP-300/AFP-400"
on page 5-8
How to wire an XP Series Transponder to the CPU.
"Combination Fire/Security
Applications" on page 5-9
How to use the control panel as a combination Fire/Security and
Security system, including the following:
• Installing a Security Tamper Switch into the CAB-400AA.
• Installing a Security Tamper Switch into the CAB-X3.
• Circuit Wiring.
"Universal Zone Coder
(UZC-256)" on page 5-12
How to install the UZC-256 and to do the following:
• Wire 12 Zone-Coded NACs.
• Wire 20 Zone-Coded NACs.
"Releasing Applications" on
page 5-18
How to install the following releasing applications:
• a Releasing Device to the MPS-400.
• a Releasing Device to an ICM-4/ICE-4 Module.
• a Releasing Device to a CMX Module.
• an N-ARA-10 Agent Release-Abort Station.
• a Combination Waterflow/Supervisory Valve Monitor.
www.PDF-Zoo.com