Notifier AFP-400 - Remote Terminal Mode (Remt)

Operating Modes $SSHQGL[ ( 7HUPLQDO ,QWHUIDFH 3URWRFRO
AFP-300/AFP-400 Installation PN 50253:C1 05/22/97 E-3
5HPRWH 7HUPLQDO 0RGH
5HP7
Functions, passwords, and special requirements of Remote Terminal Mode (RemT) are:
Table E-3 summarizes the functions available with the RemT mode:
7DEOH ( 5HP7 )XQFWLRQV
Functions:
Read Status only. See Table E-3.
Passwords:
None
Requirements:
Use with UL EDP-listed terminals, including personal
computers with Veri•Fire™ Upload/Download software or
terminal emulation software. Intended for terminals connected
through modems, including FSK modems connected through a
public switched telephone network.
Functions Lets you...
Read Status • Display the status of an individual point (Detector, Module, Panel
Circuit, or Zone).
• Display a list of all the points in Alarm or trouble.
• Display a list of all programmed points in the system.
• Step through the history buffer event by event.
• Display the entire history buffer.
Alter Status N/A
Control Functions N/A
www.PDF-Zoo.com