Notifier AM2020

3-10
Programming 15088:J 10/22/99
1= PSYS
Select Partial System
Programming Submenu
Option 1-9
1 = INST
(install/remove loop
interface boards)
2 = STY
(choose NFPA style for SLC
loops)
3 = TDLY
(setting of alarm verification,
signal silence, etc.)
4 = AVPS
(program # of supplies for
system)
5 = ZBND
(set the boundary for
software memory map)
6 = EXTEQ
(select options for CRT
monitor and/or printer)
7 = LOCP
(enable/disable piezo
sounder, LIB local mode, &
NFPA prog)
8 = ISIB
(install/remove ISIB)
9 = PARM
(day/night sensitivity
settings, etc.)
Figure 1-2 Partial System Programming Submenu Flow Chart
see Figure 1-3
see Figure 1-4
see Figure 1-5
see Section 1.1.4
Note: Include the
number of devices
employing the trouble
bus.
see Section 1.1.5
see Figure 1-6
see Figure 1-7
see Figure 1-8
see Figure 1-9
www.PDF-Zoo.com