Notifier AM2020 User Manual

3-18
Programming 15088:J 10/22/99
Figure 1-7 Local Parameter Option Flow Chart
Section 1.1.7 Local Parameters   D }X1X7X
7=LOCP
Option 7 of the Partial System Programming Menu allows the changing of Local Parameters, such as enabling/
disabling the panel’s piezo sounder (for trouble conditions while programming SLC Loop devices into memory),
LIB Local Mode, NFPA listings, battery parameters, event reminder, device blink, and pre-alarm programming.
Change
Piezo
Condition?
Chane
LIB Local
Mode?
Enable/Disable
Silencing of Piezo
during Prog
Enter Max Address
for Control Module
(1-99)
Program
Local
Mode?
Enter Max
Address For
Detector (1-99)
Yes
Enter Max Address
For Monitor Module
(1-99)
Change
NFPA
Listing?
Select NFPA
Listing
Program/
Remove Listing
Yes
No
Change
Battery
Prog?
Yes
Yes
Enter Battery
Type
Yes
7 = LOCP
Enter Battery
Cpacity
(9-32 AHR)
Enter Battery
Standby Time
Change
Event
Reminder?
Enable/Disable
Event Reminder
Change
Device
Blink?
Enable/Disable
Device Blink
Yes
Yes
No
(Exit Prog Mode)
Enable/Disable
High Rate
Charge
No
No
No
No
No
NICAD
Battery?
Yes
No
Local Mode
Addresses
Cleared
Change
Pre-Alarm
Function?
Enable/Disable
Pre-Alarm
Function
Yes
No
www.PDF-Zoo.com

Notifier AM2020 Specifications

General

Brand	Notifier
Model	AM2020
Category	Fire Alarms
Language	English