1-31
Installation 15088: J 10/22/99
Section 2.8 Mounting the MOD-1 Module Plate
The MOD-1 allows a single MMX-1, MMX-2 or CMX module to mount in a CAB-3. It occupies one of the four
positions available in a row on the CHS-4 or CHS-4L Chassis. The following five steps describe how to mount
the MOD-1 in a chassis, and Figure 2.8-1 illustrates the five steps of this installation.
1. Firmly press the module to be installed into the square opening on the MOD-1 until it snaps
into place.
2. Secure the module to the MOD-1 with the two screws provided. Make connections to the
module at this time.
3. Angle the bottom edge of the MOD-1 into the slot on the bottom of a chassis position. Swing
the MOD-1 assembly into the chassis.
4. Secure the assembly to the chassis by tightening the captive screws on the MOD-1.
5. To install the CHS-4L chassis, follow Steps 1 and 2 above. After completing Step 2, screw the
two standoffs provided to the upper studs of a CHS-4L chassis position as shown in Step 5 of
Figure 2.8-1. Then continue on with Steps 3 and 4.
www.PDF-Zoo.com
To Next Page
Loading...
